Step 6 - Ethernet Setup
Network settings
Last updated
Network settings
Last updated
Press Win + R type ncpa.cpl and click Ok
Right-Click your Ethernet and click on Properties
Configure it as shown below:
(Scroll down and disable the Rest)
Click Configure
Switch to Advanced and configure the following properties:
Advanced EEE - Disabled
ARP Offload - Disabled
Flow Control - Disabled
IPv4 Checksum Offload - Disabled
Large Send offload v2 (IPv6) - Disabled
Network Address - Not Present
TCP Checksum Offload (IPv6 ) - Disabled
UDP Checksum Offload (IPv6 ) - Disabled
If you don't have some of these options skip them and move on to the next step.
Restart your pc.
Open CMD as ADMISTRATOR AGAIN (and type those commands in delay of 5s) arp -d netsh interface IP delete arpcache Now, Restart your pc.
Search on google: my IP
.
Go to the first when site and save your IP address.
Check what is your IP, screenshot it. Disconnect your router (WiFi) for 6 minutes and connect it back. Compare the IP serials, + use VPN (WINDSCRIBE) for 14 days (THE ONE BELOW ONLY).
Restart PC, check if your IP changed.
You Should see here ONLY ethernet. Verify its verified and you did all at
IF YOU COMPLETED AMD RAID (Raidable)/ INTEL RAID (Raid0) YOU DO NOT NEED VPN
Download Windscribe
Open CMD as ADMINSTRATOR (and type those commands in delay of 30s between each other.) ipconfig /flushdns ipconfig /registerdns ipconfig /release ipconfig /renew netsh winsock reset Now, restart your pc.
Enter Your Username + Password you got after buying the Vpn in our website:
Login And Press : WireGuard
Select : Stealth
Final Result: